Publicidad
Step 3
Step
Separate the EXTENSION SLIDES (MM) from the
å
EXTENSION RAILS (LL) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten two EXTENSION RAILS (LL) to the INNER ENDS (C
å
and D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
LL
Open end
Page 8
MM
Push the lever in and pull the SLIDE from the RAIL.
D
LL
C
417698
Remember:
Righty tighty.
Lefty loosey.
LL
Open end
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Publicidad
