Publicidad
Step
Step 20
Carefully stand your unit upright.
å
Fasten the CENTER FRONT BRACE (T) to the CENTER FRONT
å
MOLDING (DD). Use two SILVER 1-5/8" MACHINE SCREWS (80S)
through the CENTER FRONT BRACE (T), CENTER FRONT
MOLDING (DD), and into the KNOBS (42K).
Fasten two EXTENSION RAILS (LL) to the UPPER ENDS (G and H).
å
Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL out to fi nd the other hole that lines up with the hole
in the END. Turn a SCREW into this hole.
www.sauder.com/services
T
H
LL
Open end
417698
Pro Tip: Lift with your
legs. And, you know,
your arms.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
LL
G
DD
42K
SILVER 1-5/8" MACHINE SCREW
(2 used for the KNOBS)
3S
Open end
80S
Page 25
Publicidad
