Publicidad
Step 25
Step
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (V) to the INNER END (D). Use the
å
screws in the HINGES.
Fasten a KNOB (42K) to the LEFT DOOR (V). Use a
å
GOLD 1" MACHINE SCREW (50S).
Peel a FELT DISC from the FELT DISC CARD (1M) and
å
stick it on the corner of the DOOR where it comes in
contact with the LEFT UPRIGHT (F).
Repeat this step for the RIGHT DOOR (U).
å
42K
V
1M
Page 30
D
F
417698
Stop
Mounting
screw
Hinge
50S
GOLD 1" MACHINE SCREW
(2 used for the KNOBS)
www.sauder.com/services
Publicidad
