Interfaces - Seca 655 Manual De Instrucciones

5.2 Interfaces

Item Device component
LAN interface
1
Power LED
2
Network LED
3
WiFi module (internal)
4
USB interface, weighing
5
platform
Reset key
6
WPS button
7
Power supply
8
connection
Display socket
9
Spirit level
10
USB interface, multi-
11
functional display
92 • seca 655/654
1 2 3 4 5
Used to connect the device to the EMR System in your institution (alternative to WiFi
connection,
seca connect 103
• Illuminated in green: Device is ready for use
• Illuminated in red: Device is defective
• Flashes green: Device is active as access point
• Flashes green: Network connection is being established
• Illuminated in green: Network connection is established
• Illuminated in red: Network connection is interrupted
Used to connect the device to the EMR System in your institution (alternative to LAN
connection, seca connect 103
Used to connect a barcode scanner ➔
page 137
• Press and hold (approx. 8 seconds): Reset settings
• Press briefly (approx. 1 second): Activate/deactivate access point function
Establish WiFi connection via WPS
Used to connect the plug-in power supply unit
• : Do not use this connection; see installation instructions for compati-
seca 655/654
ble seca products
Indicates whether the device is horizontal
• Used to connect a barcode scanner ➔
page 137
• Recommended if the multifunctional display is mounted directly on the device;
accessory required: Scanner holder
parts, page 137
6 7 8 9 10
Function
software required).
software required).
Optional accessories and spare parts,
Optional accessories and spare parts,
seca 463
11
12
➔
Optional accessories and spare