Adapting Device Settings; Transporting The Device - Seca 655 Manual De Instrucciones

5.7 Adapting device settings

5.8 Transporting the device

96 • seca 655/654
2. Position the drip guard on the connection panel as shown in the
illustration.
3. Push the drip guard beneath the weighing platform up to the stop.
You have the following options for setting the device up for different usage
situations:
• ➔
Changing the device mode, page 106
• ➔
Calling up/exiting a menu, page 107
• ➔
Setting up network functions, page 115
• ➔
Calibrating ultrasonic height measurement, page 109
pendent)
The device is equipped with two casters which enable transport over short
distances.
CAUTION!
Risk of injury and damage to device
If the device is equipped with a measuring rod, it must be tilted exten-
sively for transport. The great height of the device can result in injuries
and damage to the device.
► Make sure that there are no other persons in the immediate vicinity.
► Make sure that there are no objects in the in the immediate vicinity.
1. Remove the drip guard.
2. Disconnect all of the device's cable connections (e.g. power supply,
network).
3. Tilt the device until it can be moved freely on the casters.
4. Transport the device to its new setup location.
5. Set up the device ➔
Setting up the device, page
6. Re-establish all cable connections.
7. Install the drip guard.
(device-de-
93.