Voice Time /Days Tamp And; Answering System Setup; Clock; Speaker Volume - GE 21028 Guia Del Usuario

NOTE: To change to "English", press the language button again.
NOTE: In remote access mode, the system follows the selected language. The
voice prompt language cannot be switched remotely.
A S
NSWERING
This section shows you how to set up your answering system to receive
incoming calls. Before you begin the set up process, you must turn on the
answering system.
• Press the answer on/off button to turn the answering system on and off.
The MESSAGES indicator lights when the answering system is on. The
indicator blinks when you have messages.
NOTE: The answering system displays "- -" when it is off.
V T /D
OICE IME
1. Make sure the answering system is ON.
2. Press and hold the DAY/CHECK button to set the day of the week.
3. Press and hold the HOUR button to set the hour (a.m. or p.m.). Example:
12AM, 1AM, or 12PM, 1PM .
4. Press and release the minute button to advance the clock in one minute
intervals. Press and hold to increase by 5-minute increments.
5. After the time is set, the real time clock will be displayed on the handset
within 1 minute.
NOTE: You must set the day manually. You may choose to set the time manually
as well though the time is automatically transmitted by your local phone
company as part of Caller ID service. If you subscribe to Caller ID service, the
current time is set automatically when you receive your first CID record.
S V
PEAKER OLUME
Use the vol (
to a comfortable level. L1 is the minimum speaker volume and L8 is
the maximum.
S
YSTEM ETUP
S R
AY TAMP AND
or ) buttons to adjust speaker volume on the base
T C
EAL IME LOCK
13