Receiver Volume Control; D O Not Disturb (Dnd); Intercom Operation; Making An Intercom Call - GE 21028 Guia Del Usuario

R V
ECEIVER OLUME
When the handset is ON (in talk mode) you may adjust the receiver volume by
pressing the CID/VOL (
from. When the maximum or minimum volume level is reached, the phone
beeps twice. VOL 1 is minimum and VOL 4 is maximum.
D N D
O OT ISTURB
DND allows you to turn off the ringer on the handsets and call screening
on the answerer at once even though the handsets have been set to High
or Low. To do this,
1. In the standby mode, press the DO NOT DISTURB button on the base.
The DND backlit indicator will turn on and " DO NOT DISTURB " shows in
each handset display.
2. To cancel, press DO NOT DISTURB again.
NOTE: You can also enable DND even when there is incoming call ringing in.
NOTE: You can also enable DND to stop the call screening after the call is
taken by the answerer.
I O
NTERCOM
The intercom feature allows you to have a conversation with another
registered handset without tying up the telephone line. And since the
telephone line is not in use, you may still receive incoming calls.
M I
AKING AN NTERCOM
1. Make sure the phone is OFF (not in talk mode).
2. Press the PAGE/INT button on the handset.
3. Use the touch-tone pad to select the handset you want to page.
NOTE: To cancel page, press the PAGE/INT button again or the *EXIT
button on the sending handset.
4. Wait for the person at the receiving handset to press the PAGE/INT button.
NOTE: If the receiving handset does not answer within two minutes, the
intercom call is automatically canceled. The originating handset displays
"NO ANSWER".
C
ONTROL
or ) button. There are four volume levels to choose
(DND)
PERATION
C
ALL
33