V
I
OICE
NSTRUCTION
If you need additional assistance, press the REVIEW button in standby
mode and follow the voice instructions.
R
ECORDING THE
For best results when recording, you should be about nine inches from the
microphone, and eliminate as much background noise as possible.
You may record 2 outgoing announcements in the answerer or choose the
default for your current outgoing announcement.
1. Make sure the answering system is ON.
2. Press and hold the announce 1 or announce 2 button until the speaker
announces " RECORD ANNOUNCEMENT AFTER TONE " .
3. Begin speaking after you hear the beep.
4. Release the button when you finish your announcement.
NOTE: If you choose not to record an outgoing announcement, a default
announcement plays instead. To return to the default announcement after you
have recorded your own outgoing announcement, press the announce 1 or 2
button and release it when you hear the beep.
Sample Outgoing Announcement
1) Sample Single Mailbox Outgoing Announcement
Hi, this is (use your name here), I can't answer the phone right now, so please leave your
name, number and a brief message after the tone, and I'll get back to you. Thanks.
NOTE: The maximum recording time for the outgoing announcement is
2 minutes.
2) Sample Multi-Mailbox Outgoing Announcement
Hi, this is (use your name here), We can't answer the phone right now, so please press 1 to
direct your message to (name 1), press 2 to direct your message to (name 2), press 3 to direct
your message to (name 3). Leave your name, number and a brief message after the tone,
and we'll get back to you soon. Thanks.
14
O
A
UTGOING
NNOUNCEMENT