Operating Instructions; Electrical Connection - Nilfisk Alto SQ 8 Manual De Instrucciones

PLEASE READ THE
OPERATING
INSTRUCTIONS AND
OBSERVE THE
ENCLOSED SAFETY
PRECAUTIONS!
INTENDED USE
When employed in
accordance with its
intended use, the
industrial vacuum cleaner
described in these
operating instructions is
suitable for picking up
non-flammable, dry dusts
and liquids. It corresponds
to dust class 'L'.
DESCRIPTION (Fig. A)
1 Handle
2 Filter cleaning button
3 Appliance switch
4 Green LED
(ready for operation)
5 Yellow LED
(clean filter element)
6 Inlet fitting
7 Dirt tank
8 Drainage hose with
ball valve
9 Retaining clamp
10 Connection lead
11 Adapter for accessories,
50 mm diameter
CAUTION!
On delivery, the
accessories are lying in the
tank and must beremoved
before the cleaner is used
for the first time.
Remove the cleaner top
section:
6
The mains plug must not
yet be inserted into a plug
socket.
• Open the retaining
clamps and lift off the
cleaner top section
(Fig. B).
• Place a bag-type filter
into the tank as
described in the
instructions (printed
on the filter).
• Fit the cleaner top
section and close the
retaining clamps.
• Connect the suction
hose.
The 'Wap MultiFit'
enables any Wap
suction hose systems
(32, 36, 50 mm
diameter) to be
connected to the
cleaner.
(Fig. C)
ASSEMBLING THE
CLEANER
If necessary:
• Press the adapter for
accessories with a 50
mm diameter into the
push-in clip (Fig. D)
ELECTRICAL
CONNECTION
The operating voltage
shown on the rating plate
must correspond to the
voltage of the mains
power supply.
• Ensure that the
cleaner is switched
off and insert the
plug of the mains lead
into a properly
installed and fused
plug socket with
earthing contact.
PICKING UP DRY
SUBSTANCES
Before picking up dry
substances, the bag-type
filter should always be
installed in the tank. It
is then easy to dispose of
the material picked up
and the service life of the
main filter element is
significantly increased. Dry
cleaning without bag-type
filter is also possible.
Inflammable substances
must not be picked up
with the cleaner!
After picking up liquids,
the filter element is damp.
Damp filter elements can
clog more quickly when
dry substances are picked
up. For this reason, the
filter element should be
dried or replaced by a dry
element before picking up
dry substances.
PICKING UP LIQUIDS
Before picking up liquids,
the bag-type filter must
always be removed from
the tank.
Inflammable liquids
must not be picked up
with the cleaner!
If foaming is observed,
stop work immediately
and empty the tank
through the drainage
hose.