Installing The Interface; Final Assembly - Metra 99-6526 Instrucciones De Instalación

Installing the Interface

With the key in the off position:
1. Connect the 18-pin harness with stripped leads into the interface.
2. Connect the 6526 harness into the interface, and then into the vehicle.
3. Connect the 4-pin black harness into the keypad on the kit.
99-6526
1. Locate the factory antenna connector in the dash, and complete all necessary
connections to the radio. Metra recommends using the proper mating adapter
from Metra.
Note: If using the ASWC-1 (sold separately), connect it after you program and
test the 99-6526, with the key in the off position.
2. Before using the kit it must be initialized.
a. Start the vehicle.
b. With the vehicle running, turn the HVAC on, wait 5 seconds, turn the vehicle
off, wait 5 seconds, and then turn the vehicle back on.
c. HVAC controls are now detected.
3. Test the radio and climate controls for proper operation.
4. Mount the completed assembly into the dash using the 99-6526 radio trim
panel, and then reassemble the dash in reverse order of disassembly.
8

Final assembly