Installing The Led Light Kit And Glass Shade - Kichler LUCIAN Manual De Instrucciones

INSTALLING THE LED LIGHT KIT
AND GLASS SHADE
NOTE: Before starting installation, disconnect the power by turning off the
circuit breaker or removing the fuse at fuse box.
Step 1. Loosen the three mounting screws on the inside of the LED light
kit. (Fig.18)
Step 2. While holding the LED light kit under the fan motor, make the wire
connections: (Fig. 18)
- Red to white
- Black to black
NOTE: If you do not plan to install the LED light kit with your fan at
this time, don't make the wire connections. Raise the decorative
bottom cover against the LED light kit and turn clockwise until
snug, DO NOT OVERTIGHTEN. (Fig. 19)
Step 3. Tuck the connections neatly into the light plate. Place the
key holes on the LED light kit over the 2 screws previously
loosened from the light plate, turn the LED light kit until it locks in
place at the narrow section of the key holes. Secure by tightening
all three screws. (Fig.18)
Step 4. Raise the glass shade against the light kit and turn
clockwise until snug, DO NOT OVERTIGHTEN. (Fig. 18)
Light plate
Wire connectors
LED light kit
Screws
Glass shade
Fig. 18
Decorative
bottom cover
Fig. 19
52" LUCIAN LED | 15
TM