Kit Assembly - Metra 99-3310B Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Slide the radio brackets into the
trim plate aligning the holes in
the trim plate to the clips on the
brackets. (Figure A)
2. Mount the pocket to the radio
brackets/trim plate assembly with
the (4) #8 x 3/8" Phillips screws
supplied. (Figure B)
3. Slide the radio into radio brackets/
trim plate assembly and secure
with the screws supplied with the
aftermarket radio. (Figure C)
4. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from Metra
and/or AXXESS.
5. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly.

Kit Assembly

(Figure A)
99-3310B
(Figure B)
3
(Figure C)