Monogram ZV830 Instrucciones De Instalación página 14

INSTALLATION—RECIRCULATING
DUCTWORK, WIRING LOCATIONS
Location
1-1/4"
NOTE: Top
mounting
screws MUST
engage wood
support.
9-7/16"
Min.
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
centerline on the template to the ceiling.
HOUSE WIRING LOCATION:
the hood.
centerline.
14
Installation Instructions
Ceiling
C L
1-1/4"
10-1/16"
TOP TOP
MOUNTING MOUNTING
NOTE: Top
HOLE HOLE
mounting
screws MUST
DRILL 1/8" DRILL 1/8"
engage wood
PILOT HOLE PILOT HOLE
support.
REAR WALL
MOUNTING TEMPLATE
15-7/16" 15-7/16" 9-7/16"
C L
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
1
INSTALL FRAMING FOR HOOD
SUPPORT
IMPORTANT:
Centerline of
installation
space
the top mounting brackets. Remove the template.
at the bracket location indicated on the template.
two wall studs at the mounting screw location. The
horizontal support must be flush with the room side
of the studs. Use cleats behind both sides of the
support to secure to wall studs.
IMPORTANT: Reinstall drywall for an even mounting
surface.
View from rear
cleats
mounting
support
49-80512 Rev. 4