Monogram ZV830 Instrucciones De Instalación página 17

INSTALLATION—RECIRCULATING
6
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
aluminum-to-copper connectors.
the knockout on the top or left side.
strain relief.
green lead or bare ground lead.
electrical connector.
cover. Be sure the wires are not pinched.
screws.
49-80512 Rev. 4
Installation Instructions
7
INSTALL DUCT COVERS
covering.
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed for
recirculating purposes. Be sure
the vented end is at the top; the
vent holes will be visible in this
installation.
The inside duct piece must slip into the folded ends
on the outer section.
Upper duct
cover
Lower duct
cover
Lower duct
cover seat
Screw holes
panel to unlock. Lower the panel to access the filter.
of the opening. Install 2 screws to secure the duct
cover to the hood.
Mounting
screws
Vent
holes
Duct cover
support bracket
Duct
attachment
tabs