Connect Electrical; Install Duct Covers - Monogram ZV830 Instrucciones De Instalación

INSTALLATION—VENTED TO THE OUTSIDE
6

CONNECT ELECTRICAL

Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
aluminum-to-copper connectors.
the knockout on the top or left side.
strain relief.
green lead or bare ground lead.
electrical connector.
cover. Be sure the wires are not pinched.
screws.
12
Installation Instructions
7

INSTALL DUCT COVERS

covering.
covers on top of the hood.
NOTE: The inside duct piece
has vent holes on one end.
The holes are intended for use
when the hood is installed for
recirculating purposes. Slide
the inside end into the outer
piece; the vent holes should not be visible in this
installation.
The inside duct piece must slip into the folded ends of
the outer section.
Upper duct
cover
Lower
duct cover
Lower duct
cover seat
Screw holes
panel to unlock. Lower the panel to access the filter.
of the opening. Install 2 screws to secure the duct
cover to the hood.
Mounting
screws
Duct cover
support bracket
Duct
attachment
tabs
49-80512 Rev. 4