Descargar Imprimir esta página

Singer SWP SMART Folleto De Instrucciones página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

• If the power cord is damaged, it must be replaced by the
manufacturer or its aftersales service, or by a person with
similar qualifications, to prevent all risks.
• This appliance is not intended for operation by means of an
external timer or with a separate remote control system, to
avoid the risk of fire if the appliance is covered or not
correctly positioned. Ensure that there are no other
appliances drawing large amounts of power on the same
electrical line.
• To avoid all risk of electric shock, never immerse the plug, the
power cord or the appliance in water or any other liquid.
• Never leave the device exposed to the weather (sun, rain,
etc.).
• Do not touch the appliance with wet hands or feet.
• Do not move the base when it is plugged in.
• Do not pull on the power cable or the appliance itself to
remove the plug from the power socket.
• Do not move the appliance by pulling the cable.
INSTALLATION
• After removing the packaging, check that the appliance is intact; if in doubt, do not
use it and call in qualified staff. Packaging components (plastic bags, expanded
polystyrene, nails, etc.) must not be left within reach of children since they are
potentially hazardous. Any stickers or advertising leaflets affixed to the appliance
must be removed prior to use.
• Before connecting the appliance, check that the voltage values marked on the
nameplate are the same as those of the electrical mains, and that the power socket is
properly earthed. If the appliance's plug is not compatible with the socket, have the
socket replaced with another of suitable type by qualified staff, who must ensure that
the socket's wire gauge is suitable for the appliance's power draw. In general, the use
of adapters and/or extension leads is not recommended; if their use is unavoidable,
they must comply with current safety regulations and their current rating (amps) must
be no lower than the maximum current draw of the appliance.
• The base of the appliance must be set on a solid, smooth, stable, heat resistant,
horizontal support surface that is free of irregularities, slip-resistant, with sufficient
16

Publicidad

loading

Este manual también es adecuado para:

Sy5510