Singer SWP SMART Folleto De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

These are the functions of each element:
Base (pos. 1).
It is provided to:
- hold the iron on the seat that
contains exactly the plate (pos. 3): the
part that extends at the end of the
plate
can
corresponding slot (pos. 4) in the seat,
and clamping is ensured by the clip
that is engaged on the rear of the
plate. To remove the iron, lift the
handle.
- contain the water tank: to remove it,
press on the centre of it fully and,
when releasing the tank, it lifts up and
comes out enough to be removed.
Carefully lift the silicon plug on the
bottom and fill the tank with water
(see the warning paragraph), and then
close the plug completely. Return the
tank to its seat, press on its centre
fully and, when releasing the tank, it
remains set in the seat and aligned
with the surface.
- contain the power cord, to be wrapped around the dedicated guide on the
bottom of the base.
Iron
It has a ceramic coated metal plate and indented
holes from which steam is distributed. Two temperature
levels can be selected: Level 1 about 90 to 120 °C; Level
2 about 120 to 150 °C. The handle of the iron has the
following command and control elements:
- Stand-by / I button (10): activates all functions of the
appliance. The button is backlit and is only on when
the appliance is in Stand-by (connected to the
electricity by without active functions). If the button is
pressed once, the light turns off and the iron heats up
to the Level 1 temperature. The corresponding LED
flashes during heating and once the temperature has
been reached, the LED indicator light stays on and
be
inserted
in
the
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sy5510

Tabla de contenido