6 - INCONVENIENCES AND POSSIbLE REMEDIES
Malfunction
The appliance doesn't work.
The appliance doesn't switch on. too much water has collected inside
The appliance only works for a
small amount of time.
The appliance doesn't cool effi-
ciently.
The appliance is noisy and vi-
brates excessively.
The appliance emits an
abnormal sound.
Water leaks from the conditioner
during transport.
In cooling, night-time or
automatic mode, minimum
speed cannot be selected.
if the problem has not been solved, please contact the nearest technical assistance service.
Please give detailed information about the malfunction and on the equipment version.
EN - 24
Cause
Current failure
the unit is disconnected from the
current.
the air conditioner.
timer is on.
the temperature set is too close to
ambient temperature.
Suction of outside air is obstructed. remove the obstructions.
The air filters are clogged by dust,
fluff or animal hair.
temperature setting is too high.
the windows or doors of the room
are open.
the room area is too large.
Heat sources are present inside the
room.
the appliance bearing surface is not
levelled.
The air filters are clogged by dust,
fluff or animal hair.
this sound is caused by the refriger-
ant flow inside the unit.
the conditioner has been tilted or
laid flat.
ambient temperature too low.
What do i do?
Wait for the current to be restored.
Check that the plug is inserted in the
wall socket.
drain the water off by removing the
plug (28). Call the assistance
Centre if this alarm occurs too often.
Switch off the timer.
lower the temperature set.
Call the Service Centre.
Switch off the appliance and clean
the filters following the instructions.
reduce the set temperature.
make sure all the windows and the
doors are closed.
Check the cooling area again.
remove the heat sources if possible.
Place the appliance on a flat and
levelled surface.
Switch the appliance off and clean
the filters following the instructions.
it is totally normal.
empty water before moving the
appliance.
air conditioner behaviour is normal.