General Recommendations - GYS POWERDUCTION 110LG Manual De Instrucciones

Translation of the original instructions
Start chronogram by PLC
Gâchette
Mecha
méca trigger
relais
external
extérieur
relay
mode
drive mode
asservissement
Safety and fault setting of the device
- If the temperature input does not change after 5 s, the product goes into fault "E12".
- If a thermocouple cuts out, then the regulation stops because the voltage U T° exceeds the maximum voltage of 4.9 V.
- If the temperature drops significantly in a short period of time (when thermocouple probes are disconnected, for ex-
ample), the heating stops and the product goes into fault "E11".
- To have the most accurate regulation possible, the measuring point(s) must be as close as possible to the inductor.
This is the reason for the 2 thermocouples on the external interface.
- The display shows the highest temperature measured by the sensors.
MAINTENANCE

General recommendations

• It is recommended to change the cooling liquid every two years, otherwise you may damage the Powerduction's lance.
Before adding the liquid, dust the product and check for leaks.
• Regularly check the tightening of the power screws and the appearance of the electrical power connections.
Recommended tightening torque for power screws
Dimensions screws M5
Material steel
Torque 4 Nm
• It is essential that the maintenance of the product is performed by qualified, authorised staff, that is fully aware of the
recommendations outlined in this manual.
• Never clean, lubricate or perform maintenance on the product when it's being used.
• Before any maintenance work, set the On / Off switch to « 0 » to switch off the machine, .then disconnect it it from
the mains power supply to prevent any electrical shock or other risks resulting from improper handling.
• Do not wear rings, watches, jewellery, hanging clothes (e.g. ties), torn clothes, scarves, unbuttoned or unzipped jack-
ets, or anyhting that could get caught during the operation of the machine
7 Nm
POWERDUCTION 110LG / 160LG / 220LG
500ms 500ms 500ms
M6 M8
steel brass
6 Nm 7 Nm
• Rather wear clothing specifically designed for the prevention of accidents, such as:
non-slip shoes, anti-noise helmets, protective goggles, safety shoes, etc ...
• Never use petrol or flammable solvents to clean the product. Prefer the use of wa-
ter and, if necessary, non toxic commercial solvents.
• After maintenance, always put and secure the metal covers back on, before switch-
ing the machine on.
• The ferrite on inducer can be replaced if damaged.
Gas
1/4
M10 clamp
Gas
3/8
brass
7 Nm 2,5 Nm 4 Nm
Inductor
M28 M32
16/22
copper copper copper
by hand,
7 Nm max 7 Nm max
4 Nm max
EN
33