Setting the impact force
NOTE
►
Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Increasing the impact force
♦
Turn the impact force control
Reducing the impact force
♦
Turn the impact force control
NOTE
►
Ensure the correct position for the nails (see
main diagram, face plate
♦
After filling, push the release
zine shaft
as far as the stop until it clicks into
place.
NOTE
►
The fill level indicator
magazine contains staples.
Use
Switching on
♦
Press the stapler nose
material that you want to staple until it is pushed
in a few millimetres.
♦
Press the trigger
│
GB │ MT
■
44
clockwise.
anticlockwise.
on the tool).
into the maga-
shows whether the
onto the part of the
.
Troubleshooting
Cause
A staple is blocking the tool.
Solution
♦
Remove the battery pack
♦
Turn the tool over.
♦
Press in the releases
♦
Pull the magazine slider
release the tension.
♦
Remove the staple.
WARNING!
■
Do not hold the power tool by the trigger
the staple is jammed in the power tool. While
removing a jammed staple, the trigger
be accidentally activated.
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always switch the tool off and
remove the battery before carrying
out any work on it.
■
The tool is maintenance-free.
■
The tool must always be kept clean, dry and
free from oil or grease.
■
Use a soft, dry cloth to clean the housing.
■
Never permit liquids to penetrate inside the tool.
■
If a lithium-ion battery is going to be stored for
an extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
NOTE
►
Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline.
from the tool.
(see fig. A).
backwards. This will
if
can
PAT 12 A1