Logs > Events - Tripp-Lite SNMPWEBCARD Guia Del Usuario

3.10 Settings > System
Watchdog Tab
The Watchdog tab provides the user the ability to set up timers
that will reboot the card automatically if the Watchdog trigger
is reached. This provides a mechanism to maximize the uptime/
accessibility of the SNMPWEBCARD. The Watchdog tab allows
enabling/disabling of either the Ping probe or NTP probe.
• Primary Ping Target: IPv4 address/hostname (requires DNS
settings to be configured).
• Secondary Ping Target: IPv4 address/hostname (requires
DNS settings to be configured) (optional).
• Ping Probe Interval:
Time in minutes before retry.
• Probe Tries Before Fail:
ping the primary and secondary IP addresses before the
SNMPWEBCARD assumes there is a problem and reboots
itself.
The SNMPWEBCARD will continue to reboot until it is
successfully able to ping the primary or secondary IP address.
• Primary NTP Target: IPv4 address (requires DNS settings
to be configured).
• Secondary NTP Target: IPv4 address/hostname (requires
DNS settings to be configured) (optional).
• NTP Probe Interval:
Time in minutes before retry.
• Probe Tries Before Fail:
from the primary and secondary NTP addresses before the
SNMPWEBCARD assumes there is a problem and reboots
itself.
The SNMPWEBCARD will continue to reboot until it is
successfully able to get time from either the primary or secondary
IP address.
Note: The Watchdog tab is applicable for Firmware version
12.04.0051 and above.
3.11 Logs > Events
Click the "Logs" menu button and the "Events" submenu button
to display the Logs > Events page (Figure 3-29). All events are
logged here with a date, time and description. Each event also
displays an icon that identifies its status: normal, critical, warning,
information or offline.
(continued)
The number of attempts to
The number of attempts to get time
Fig. 3-28: Settings > System > Watchdog
Figure 3-29: Logs > Events Page
14