Settings > Contacts - Tripp-Lite SNMPWEBCARD Guia Del Usuario

3.8 Settings > Contacts
Click the "Settings" menu button and the "Contacts" submenu
button to display the Settings > Contact Settings page.
The "Email" tab (Figure 3-14) shows a table of e-mail contacts.
Before your SNMPWEBCARD can send e-mail notifications, you
must enter e-mail server information and add at least one e-mail
contact. Click the "SMTP Settings" button to enter the settings for
your mail server. If you do not know the correct settings, contact
your network administrator. Add a new email contact by clicking
the "New" button and entering the information requested, and
save. Test your settings by highlighting/selecting an email contact,
then click the "Send Test Email" button.
Additional requirements for E-mail settings:
1. Enter a valid IP address or DNS name for the SMTP mail
server. (Using a DNS name requires valid DNS server settings.
You will have the option to enter two: "Preferred DNS Server"
and "Alternate DNS Server". See Section 3.9 Settings >
Network.)
2. If SMTP authentication is required, obtain the authentication
information from your network Administrator (see Figure
3-14a).
3. The mail server must be set up to relay e-mail from the subnet
or IP address of the SNMPWEBCARD if SMTP Authentication
is not being used.
4. The "To" and "From" addresses must be valid.
The "SNMP" tab (Figure 3-15) shows a table of SNMP contacts.
Before your SNMPWEBCARD can send an SNMP trap or SNMP
set to an IP address, you must add at least one SNMP contact.
Add a new contact by clicking the "New" button and entering the
information requested, and save. If you do not know the correct
settings, contact your network administrator. (The standard port
for SNMP set destinations is port 161. The standard port for
SNMP trap recipients is port 162.)
Note: If adding an SNMP contact to be used with a SNMP Set
Notification, use port 161 or the port number that the remote
SNMP device can be accessed on. After adding Email and SNMP
contacts, the user must set contacts for trap sending during events
via Settings>Events (see 3.7 Settings>Events).
Note: You also need to configure and enable each event setting
through the Settings>Events window before notifications can be
sent to your contacts.
Figure 3-14: Settings > Contacts > Email Tab
Figure 3-14a: Settings > Contacts > Email Tab > SMTP Server Settings
Figure 3-15: Settings > Contacts > SNMP Tab
9