essentiel b ERLVI 180-55b1 Manual De Utilización página 34

Problems
The appliance does not cool
down enough.
The food is too warm.
The compressor does not
start immediately
changing the temperature
setting.
There is water at the back
of the appliance or on the
shelves.
If the information in this table does not help you solve your specific problem, do not perform
any repairs on the appliance yourself. Contact your retailer's after-sales department.
Repairs to your appliance should only be performed by qualified service
technicians. Improper repairs can lead to hazards for users and are not covered
by the warranty.
In case of prolonged absence or non-use
• Switch the appliance off by pressing the on/off button for 3 seconds.
• Unplug, empty, defrost and clean the appliance.
• Keep the doors ajar when the appliance is unplugged and not in use.
34
V.1.0
troubleshooting guide
Possible causes
The temperature is not set
correctly.
The door stayed open for a
long time.
A large amount of hot food has
been placed in the appliance in
the past 24 hours.
The appliance is located near a
heat source.
This is normal, it is not a
after malfunction.
The discharge outlet for the
defrost water is blocked.
Solutions
Please refer to the "Setting the
temperature" section.
Do not open the door longer than
necessary.
Temporarily set the
to a cooler temperature. Avoid
overloading the inside
refrigerator.
Please refer to the
installation" section.
The compressor will start after a
while.
Refer to the "Cleaning
Maintenance" section.
thermostat
of the
"Place of
and