Getting Started; Control Panel - essentiel b ERLVI 180-55b1 Manual De Utilización

use

Getting started

1. Please let the appliance rest for 2 hours if it was transported in an upright position, or
24 hours if it was transported in a horizontal position, before plugging it into the mains
socket for the first time. This is to allow the refrigerant gas to go back down into the
compressor. Not respecting this waiting period may damage the compressor.
2. Plug the appliance into an earthed socket.

Control panel

1. Plug the appliance in and the thermostat will operate at level 4.
2. When the refrigerator door is opened, the control panel lights up and the lamps in the
refrigerator compartment come on. The fan in the refrigerator stops. Sixty seconds after
the door is opened, the open door alarm sounds. 420 seconds after the door is opened,
the lighting switches off automatically but can be reactivated by pressing the switch.
When the refrigerator door is opened, the control panel lights up. When the door is
closed, the lighting goes out and the control panel switches off after 60 seconds.
3. To adjust the interior temperature, please press the
6 to obtain the most suitable temperature.
4. To switch off the appliance, press the
up. The power supply is off. The interior light goes out, the compressor stops running.
Press the button
and the appliance is back on.
5. On models that do not have No Frost technology, you can force defrost it. It is essential
to defrost the appliance for maintenance or cleaning of the model. Press the
buttons for 3 seconds to start forced defrosting. The
automatically stops when the sensor detects a temperature between 10 ~ 12 °C. Press
the + buttons for 3 seconds to turn off the manual forced defrost. The button will
stop flashing.
6. Fault and alarm display.
This unit is equipped with a "fault and alarm display" function. If the sensors detect a
fault, the corresponding digit flashes on the control panel.
1 – Refrigerator compartment sensor
2 – Freezer evaporator sensor
3 – Freezer sensor
The appliance is still cooling, but a professional technician should be contacted to check
the appliance.
for 3 seconds to switch your appliance back on. The symbol flashes,
button and choose from levels 1 to
button for 3 seconds. The button will then light
button flashes. The function
+
29
V.1.0
use