Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FORWARD-FACING
EN
WARNING: If the child is not secured properly, child could be ejected in a sudden stop or crash, resulting in serious injury or death.
WARNING: If in doubt about the installation, consult either the enhanced child restraint system manufacturer or the retailer.
IMPORTANT - DO NOT USE FORWARD FACING BEFORE THE CHILD'S AGE EXCEEDS 15 MONTHS.
INSTALLATION WITH ISOFIX AND TOP TETHER (76-105 CM)
1.
Place enhanced child restraint system forward-facing (in the
direction of travel) in proper seating location, flat on the vehicle seat
bottom and touching vehicle seat-back.
2.
Press the ISOFIX button to pull out the two ISOFIX locking arms from
the base bottom.
You will hear an audible CLICK!
indicator turns into a red colour, which means ISOFIX attachments
are unlocked.
NOTE: The ISOFIX attachment points are located between the surface and
the backrest of the vehicle seat.
3.
Align ISOFIX attachments to the metal anchorages at the bottom
of the car seat's backrest and push it until it clicks.
audible CLICK! Ensure both sides of the ISOFIX locking arms turn into
green safety colour.
CAUTION: After the ISOFIX installation check if the enhanced child
restraint system is securely fitted. If the enhanced child restraint system is
not stable and is shaking, reinstall.
4.
Select a position from 1 to 4.
5.
To use the top tether, remove it by loosening the strap and unclipping
it from the storage anchor.
NOTE: Some vehicles have a third ISOFIX attachment point for a top
tether, behind the rear seat to stop the enhanced child restraint system
tipping forward in an accident. Check whether you car is equipped with it.
6.
To extend the top tether, press the top tether adjuster button and pull
to lengthen the strap.
7.
Hang the latch behind the rear seat on the attachment point. There are
3 possible options on how to fix the latch. Refer to the illustration below.
8.
Ensure the top tether clip is tightened up.
NOTE: For the safety of your child, the top tether must be tightened up
during driving.
WARNING: Check that enhanced child restraint system is securely installed before each use.
INSTALLATION WITH ISOFIX AND VEHICLE SEAT BELT (100-135 CM)
NOTE: When using this enhanced child restraint system as a booster seat, remove the 5-point harness.
1.
Place enhanced child restraint system forward-facing (in the direction of travel) in proper seating location, flat on the vehicle seat
bottom and touching vehicle seat-back.
2.
Press the ISOFIX button to pull out the two ISOFIX locking arms from the base bottom.
indicator turns into a red colour, which means ISOFIX attachments are unlocked. Ignore
the steps regarding ISOFIX, if you don't want to use ISOFIX connector.
NOTE: The ISOFIX attachment points are located between the surface and the backrest of the
vehicle seat.
3.
Align ISOFIX attachments to the metal anchorages at the bottom of the car seat's backrest
and push it until it clicks.
locking arms turn into green safety colour.
CAUTION: After the ISOFIX installation check if the enhanced child restraint system is securely
fitted. If the enhanced child restraint system is not stable and is shaking, reinstall.
4.
Select a position 1.
5.
First, pull out the belt from the belt ALR. Shoulder belt through the same side of guidance
1, lap belt through the same side of guidance 3, then pull the shoulder belt and lap belt
together through another side of guidance 3.
6.
To fasten the seat belt across child: lap portion of the vehicle seat belt should rest within both
lower belt guides with buckle located on the outside of the enhanced child restraint system.
7.
Place shoulder portion into the upper belt guide on the headrest so that belt lays properly
across child: on the collar bone, interior (A) to the shoulder (B).
8.
Make sure seat belt is not twisted and remove slack from seatbelt so it lays flat, smooth
and snug across child in all locations.
9.
Fasten the vehicle seat belt. You will hear an audible CLICK! Pull the seat belt tight to make
sure it is not twisted.
CAUTION: The shoulder seat belt section must run diagonally backward. You can adjust the course of the belt with your vehicle's adjustable
belt deflector on both sides.
CLICK
38
INSTALLATION
Ensure that the
You will hear an
You will hear an audible CLICK! Ensure both sides of the ISOFIX
A
B
CLICK
You will hear an audible CLICK!
Ensure that the
CLICK
Publicidad
Tabla de contenido
