Programming Menu; Default Parameters; Table: Parameter Sets; Setting The Basic Function - Kübler CODIX 924-6 Manual Del Usuario

Pressing the Prog/Mode key
acknowledges this prompt and
terminates the programming; the
modified settings are saved in
the EEPROM.
7.8

Programming Menu

7.8.1 Default parameters

Note: Three default parameter
sets have been permanently
stored; these can be adapted as
required. With each
acknowledgment of the
parameter sets, all parameters
will be reset to the values listed
in the table.
The dEFAuL P.USEr can be
freely programmed.
Menu Parameter Sets
Default setting
Parameter set 1
Default setting
Parameter set 2
Default setting
Parameter set 3
Freely programmable
User settings
Factory settings are highlighted
in grey
Page 8

The text SAVE is
displayed for 2 s

7.8.2 Table: Parameter Sets

P.SEt 1
Count
Func
PnP
InP.PoL
on
FiLtEr
Cnt.dir
Count
MPi LAtch
ProG
Loc.InP
Add
ModE
01.0000
FActor
01.0000
diViSo
0
dP
000000
SEtPt
red.Grn
CoLor
Man.EL
rESmd
Pr.Out 1
t.Out 1
Pr.Out 2
t.Out 2
Pr.Out 3
t.Out 3
Pr.Out 4
t.Out 4
Pr.Out 5
t.Out 5
Pr.Out 6
t.Out 6

7.8.3 Setting the Basic Function

Basic function menu
Programming menu
Pulse counter (7.8.4)
Programming menu
Timer/Hour meter (7.8.6)
Programming menu
Tacho/Frequency meter (7.8.5)
P.SEt 2 P.SET 3
Count Count
PnP PnP
oFF oFF
uP.dn Quad
LAtch Set
ProG ProG
Sub AddAr
01.0000 01.0000
01.0000 01.0000
0 0.00
000000 0000.00
red.Grn red.Grn
Man.EL Man.EL
00.10
00.10 00.10
00.10
00.10
00.10
00.10
www.kuebler.com