Assembly - Klarstein SKY HIGH Manual De Instrucciones

EN
14

ASSEMBLY

1. Remove the two parts of the base from the box, so that the holes of the two-part
base are aligned and the two parts are formed into a complete base. (As shown in
Fig. 1)
2. Run the power cord through the base, align the base with the holes on the fan body,
then secure the power cord under the base clip to tighten the base with the fan
body. (As shown in Fig. 2)
3. When the base is disassembled, screw out the screws first, then take the base out.
(The method to disassemble the base is as shown in Fig. 3)
After the four posts are aligned and wrapped, firmly snap the base front inward (a
sound can be heard), then use the same method to snap the base back.
1