Festo CPA-SC Manual De Instrucciones página 19

3 Controlling the valve terminal
Control the valve terminal in a uniform manner.
Preferably, all control signals should be positive-switching
(1-switching), otherwise all control signals negative-
switching (0-switching). Mixed mode control is not per-
mitted.
3.1 Address assignment of the valves
– Addresses should be assigned in ascending order from
left to right, on the individual valve locations from the
front to the rear.
– A valve location for controlling one coil occupies one
address.
– A valve location for controlling two coils occupies two
addresses. The following assignment applies here:
– coil 14: lower value address
– coil 12: higher-value address.
Festo CPASC-... 0202NH English 19