Tripp-Lite SmartOnline SU10KRT3U El Manual Del Propietario página 20

Operation
Bypass Messages
While in BYPASS mode, the UPS system monitors utility input voltage and supplies
filtered AC power to connected equipment.
If utility voltage deviates from an acceptable range (between 15% higher and 20% lower
than nominal), the UPS system reports the condition on the control panel's LCD and
stops supplying AC power to connected equipment. If utility voltage returns to an
acceptable level, the UPS system resumes supplying AC power to connected equipment
and the control panel's LCD reports that output voltage was too high or too low at one
time, but has returned to nominal.
Shutdown Messages
The UPS system will shut down and the control panel's LCD will display a message if it detects one of the following conditions.
Note: During all these conditions, the "Input, " "Output" and "Bypass" LEDs will illuminate.
SHUTDOWN CONDITION
Remote Shutdown
Command via DB9
Remote Shutdown
Command via EPO
201102089 93-2982.indb 20
continued
LCD MESSAGE
SHUT DOWN
REMOTE COMMAND
SHUT DOWN
EMERGENCY STOP!
20
7/11/2011 3:49:32 PM