Westin 27-1775 Instrucciones

AUTOMOTIVE PRODUCTS, INC.
MOUNT KIT
EQUIPO DE MONTAJE
OPTIONAL LIGHT
JEU DE MONTAGE
27-1775
SURE-GRIP
BOARDS
27-6150
27-6155
27-6550
ITEM
QTY
1 2 STEP BOARD (PURCHASED SEPARATELY)
2 4 FRONT/CENTER BRACKET
3 2 REAR BRACKET
4 20 M8-1.25 X 30MM HEX HEAD BOLT
5 20 8MM FLAT WASHER
6 20 8MM LOCK WASHER
7 12 5/16-18 X .75" SQUARE HEAD BOLT
8 12 5/16" FLAT WASHER
9 12 5/16-18 LOCK NUT
1 2 ESTRIBOS (SE COMPRAN POR SEPARADO)
2 4 SOPORTE DELANTERAS-CENTRAL
3 2 SOPORTE TRASERAS
4 20 PERNOS CON CABEZA HEXAGONAL M8-1,25 X 30MM
5 20 ARANDELAS PLANAS DE 8MM
6 20 ARANDELAS DE PRESIÓN DE 8MM
7 12 PERNOS CON CABEZA CUADRADA DE 5/16"
8 12 ARANDELAS PLANAS DE 5/16"
9 12 TUERCA PRESIÓN DE 5/16-18
1 2 MARCHEPIED (VENDU SÉPARÉMENT)
2 4 SUPPORTS AVANT/CENTRAL
3 2 SUPPORTS ARRIERE
4 20 BOULON A TETE HEXAGONALE M8-1,25 X 30MM
5 20 RONDELLE PLATE 8MM
6 20 RONDELLE A FREIN DE 8MM
7 12 BOULON A TETE CARREE 5/16 PO
8 12 RONDELLE PLATE SAE 5/16 PO
9 12 ECROU A FREIN 5/16-18
STEP 1. Remove contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning. It is
strongly recommended to install the Sure Grip Gap Strip for these vehicle applications.
Both front and center brackets are the same for each side. Rear brackets are also the same for each side.
STEP 2.
Locate driver side mounting locations on vehicle. SEE FIGURES 1, 2 AND 3.
STEP 3.
STEP 4. Attach brackets to underside of rocker panel as shown. Hand tighten. SEE FIGURES 1 AND 2.
Insert square head bolts as shown (3 per slot, 6 per Step board/Running board) SEE FIGURE 7. NOTE: For lighted boards, run wiring harness
STEP 5.
prior to attaching board to brackets (refer to Step 7). SEE FIGURES 7 AND 9. Run longer wire harness on passenger side.
STEP 6. For Sure-Grip Running Boards, slide closure strip as shown. Set lights (if purchased) in appropriate location. Attach to Sure-Grip Running Board
as shown. SEE FIGURE 4. Drill hole through plastic strip and run wires as shown. SEE FIGURE 5.
Attach board to brackets as shown. Make sure board and brackets are properly aligned and tighten fasteners. Recommended torque
STEP 7.
values are 10 FT.LBS. for 5/16" square head fasteners and 23 FT.LBS. for 8MM fasteners. SEE FIGURES 1, 2, 3 AND 6.
WARNING: INSTALLING LIGHT HARNESS REQUIRES SPLICING INTO VEHICLES ELECTRICAL SYSTEM. WESTIN RECOMMENDS USING A PROFESSIONAL FOR
THIS INSTALLATION. NOTE: AVOID AREAS OF EXCESSIVE HEAT, VIBRATION, PINCH OR ROTATION WHEN SECURING HARNESS TO VEHICLE.
SEE FIGURE 4. For Sure-Grip Running Boards, run wire loom down center as shown. SEE FIGURE 7.
STEP 8. Determine whether your vehicle has a positive or negative switching courtesy system or an auxiliary light source (most Fords). Obtain an
accurate wiring diagram for your vehicle's courtesy light system.
For positive and negative switching:
Locate a pass-through point (usually under carpet at driver side door sill) for the wire harness. Locate main courtesy wire (usually wire lead to
dome light). NOTE: If you do not use the main courtesy wire, lights will only function when one door is open. Route wire harness so that the 2
female connections (from step board) are nearest to pass thru point.*Connect opposite step board lead to either connection. Connect
the splicing lead to remaining female socket and route one wire thru pass thru point. SEE FIGURE 8.
VERY IMPORTANT - Double check that your system has positive or negative switching.
For positive switching only: Connect positive wire to main courtesy system, (usually wire lead to dome light). TEST CONTINUITY BEFORE
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION: 2006-UP HONDA RIDGELINE
APLICACIÓN: HONDA RIDGELINE, MOD. 2006 Y SUPERIOR
APPLICATION: HONDA RIDGELINE 2006-UP
SURE-GRIP
KIT
27-6000
1
CONTENTS - CONTENIDO - CONTENU
CAUTION: ALWAYS USE A FUSED(+) POSITIVE SUPPLY SOURCE. UNDERCOAT SEAL FOR HARSH WEATHER.
2
TOOLS - HERRAMIENTA - OUTILS
1/2" SOCKET
13MM SOCKET
RATCHET
TORQUE WRENCH
DADO DE 1/2"
DADO DE 13MM
MANERAL
LLAVE DE TORQUE
DOUILLE 1/2 PO
DOUILLE 13MM
CLIQUET
CLE DE COUPLE
WO:
75-0778 REVISION C 6/30/08
3