nVent RAYCHEM SC-JBS-S-A Instrucciones De Instalación página 3

5
• Push braid forward. Use a
screwdriver to open braid.
• Bend heating cable and work it
through opening in braid.
3SC heating cable shown.
• Pull braid tight to make pigtail.
7
• Pull heating cable back into stand as shown. Use cable
lubricant if needed.
• Repeat Steps 3 through 7 for second heating cable.
8
• Fasten stand to pipe. Do not
pinch heating cables.
• Loop and tape extra heating
cable to pipe.
6
• Remove 3/4-inch (20 mm) insulation and fiberglass
braid from end of each conductor.
3SC heating cable shown.
Pipe strap
Glass cloth tape
3/4 in.
(20 mm)
Fiberglass
braid (only for SC, SC/H)
1-1/2 in.
(38 mm)
WARNING: Fire and Shock Hazard.
To prevent cable damage and shorting,
position pipe straps under the heating
cable. Ensure the cable does not cross
over itself.
nVent.com | 3