Items Supplied - Hilti DX 450 Manual Del Usuario

DX 450-FA
Area of application:
▶ Corrosion-resistant fastening of glass-facade attachment profiles to steel supporting structures (e.g.
glass facades, conservatories, marquees, stairwells).
DX 450-USS
Area of application:
▶ Exclusively for fastening rails to steel. The fastener must be set inside the rail.
Use the product only in combination with the equipment designed for use with the fastening tool. Base
plates, fastener guides, pistons and fasteners must be compatible with one another.
Use the product only with spare parts and accessories from Hilti and with cartridges and fasteners from
Hilti, or other suitable cartridges and fasteners.
3.4 Requirements to be met by cartridges
WARNING
Risk of injury by unexpected explosion!
requirements can lead to a build-up of unburned powder. A sudden explosion and severe injuries to the
operator and bystanders can result.
▶ Use only cartridges that meet the minimum safety requirements of your local statutory regulations!
▶ Adhere to the maintenance intervals as stated and have the fastening tool cleaned regularly by Hilti-
Service!
Use only the Hilti DX cartridges listed in this table, or other suitable cartridges that are compliant with the
minimum safety requirements:
• It is a requirement for EU and EFTA countries that the cartridges must be CE-compliant and must bear
the CE mark of compliance.
• It is a requirement for the USA that the cartridges must be compliant with the stipulations set out in
ANSI A10.3-2020.
• It is a requirement for the non-European member states of the C.I.P. that the cartridges must have C.I.P.
approval for the DX fastening tool used.
• It is a requirement for the remaining countries that the cartridges must have passed the firing-residues
test in accordance with EN 16264 and must have a manufacturer's declaration to this effect.
Cartridges
Comply with the instructions for use in the operating instructions of the fastener used, in the Hilti
Direct Fastening Technology Manual or the corresponding local Hilti 'Technical Guide to Fastening
Technology'.
Ordering designation
6.8/11M cartridge
3.5

Items supplied

Fastening tool, base plate, cleaning set, safety data sheet (cartridges), quick guide, operating instructions
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.6 Minimum distances and spacing
You must always observe certain minimum distances and spacing when driving fasteners. They can differ,
depending on the product.
For detailed information, request a copy of the Hilti 'Direct Fastening Technology Manual' or the
corresponding local Hilti 'Technical Guide to Fastening Technology' from your Hilti Store.
22 English
Use of cartridges that do not meet the minimum safety
Color
red
yellow
2338162
Power level
(charge)
strong
medium
*2338162*