Hilti PD-C Manual Del Usuario página 31

▶ Disposal of electric tools or appliances together with household
waste is not permissible.
11 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about
the warranty conditions.
12 FCC statement (applicable in US) / IC statement (applicable in
Canada)
Note
This equipment has been tested and found to comply with the limits for
a class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by taking
the following measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to a power outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced TV/radio technician for assistance.
Note
Changes or modifications not expressly approved by Hilti may restrict
the user's authorization to operate the equipment.
This device is in compliance with paragraph 15 of the FCC Regulations RSS-
210 of the ISED Regulations.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference
that may cause undesired operation.
13 Identification number of the notified body
American Certification Body (ACB)
English 27