Installing The Fairlight Panels - Blackmagic Design Fairlight Manual De Instrucciones

4 Once the legs and feet are attached, lean the chassis onto its feet into its
standing position.
Lean the Fairlight console onto its feet, ready to install the Fairlight panels
With the legs and feet attached to the console chassis, you can now install the Fairlight panels.

Installing the Fairlight Panels

The most common layout Fairlight audio engineers use for mounting the modules is to place
the Fairlight Console Audio Editor directly in front of the operator, the Fairlight Console Channel
Control and Channel Fader modules on each side, and the channel control modules above
each channel fader module. Their respective LCD monitors are installed along the top with the
monitor infill module. The small surface in between the Fairlight modules is for a mouse
or trackball.
If you don't have all the modules for a full console, you can fill in the spaces with blank panels
until you are ready to add more modules later. You can add modules any time you like and as
you need them based on your production requirements.
Unpacking and Assembling 12