Safety Information - Blackmagic Design Fairlight Manual De Instrucciones

Safety Information

Weight Warning
The Fairlight Console has considerable weight even when empty. For example, a 3 Bay console
weighs up to 110 kg empty, and 157 kg fully assembled. You should always move a Fairlight
console with at least 4 people using safe lifting procedures, such as keeping the back straight,
bending the knees and lifting with careful, controlled movements.
Electrical Warning Notice and Disclaimer
For installations involving the fitting of more than five Fairlight modules, additional earthing
requirements must be fitted before connecting the supply. This requirement does not apply
if each group of five Fairlight modules can be connected to separate wall or floor
socket outlets.
Earth posts are welded internally at both ends of the console frame for connecting earth
wires from the console frame to the building earth point. Either of these posts can be used
and they are marked with the following label.
Blackmagic Design recommends appointing a qualified and licenced electrician to install,
test and commission this wiring system.
Blackmagic Design does not accept responsibility for the safety, reliability, damage or
personal injury caused to, or by, any third-party equipment fitted into the console.
To reduce the risk of electric shock, do not expose this equipment to dripping or splashing.
Ensure that adequate ventilation is provided around the product and is not restricted.
Use only at altitudes not more than 2000m above sea level.
No operator serviceable parts inside. Refer servicing to your local Blackmagic Design
service centre.
State of California statement
This product can expose you to chemicals such as trace amounts of polybrominated biphenyls
within plastic parts, which is known to the state of California to cause cancer and birth defects
or other reproductive harm.
For more information go to www.P65Warnings.ca.gov.
Safety Information 29