Attaching The Monitor Infill Module - Blackmagic Design Fairlight Manual De Instrucciones

Lower the support brace by holding the brace handles and rotating the brace down from the bracket.
Allow the feet of the brace to rest inside and against the front of the chassis so it cannot move.

Attaching the Monitor Infill Module

Inside the road case, you'll find a small cardboard box. This box contains the LCD monitor
infill module that is installed next to the Fairlight console's LCD monitors.
Remove the infill bracket from the chassis following the same procedure used for the other
module brackets.
To attach the infill module:
1 Place the monitor infill module into the neck of the bracket.
2 Secure the infill module to the bracket using the supplied M4 Pozidriv screws.
Tighten to a torque of 0.45Nm.
3 Place the bracket back into the chassis.
Unpacking and Assembling 15