Tools Required; Attaching The Legs To The Console Chassis - Blackmagic Design Fairlight Manual De Instrucciones

Alternatively, if assembling the console with two or more people, you can stand the chassis on
its rear panel while attaching the legs and feet. Refer to the next section named 'Alternative
Assembly with Two or More People' for more details.

Tools Required

For assembly you will need the following tools:
We recommend using torque tools for tightening only, and using a regular wrench or driver
for removing the screws.

Attaching the Legs to the Console Chassis

The road case contains two legs that attach to each side of the console chassis. When
purchasing a Fairlight console, you can choose from two separate leg designs.
Fairlight Console Leg Kit 0 degrees
This option places the console's surface level to the ground.
Fairlight Console Leg Kit 8 degrees
This option places the console at an 8 degree angle so the console leans toward the operator.
Before attaching the legs to the chassis, you should first secure the feet to each leg.
Each assembled leg weighs 8 to 10 kilograms, so please take care when lifting.
The feet are attached to the console chassis
with their length longer at one end. Ensure the
longer end is facing the front of the console.
1 x Torque wrench with
18 mm socket capable of 35 Nm.
1 x Pozidriv 2 torque driver capable
of 0.45 Nm for M3 and M4 screws.
When the 8 degrees leg kit is attached,
your Fairlight console will be slightly
higher and tilted towards you.
Unpacking and Assembling 8