Tabla de contenido
Publicidad
J
I
A
B
FC
C
FC
L
INSPECTION
ING
Before each use, inspect vacuum
anchor for damaged, worn, loose, or
missing components. Inspect vacuum
Do not use
ry anchor
pads and hoses for cuts or other
pad unless nchor pad is
damage. Periodically, according to
attached to ng surface
conditions of use, a competent person
and vacuum indicates green.
other than the user must inspect the
vacuum anchor. See user manual for
SEC ARY
inspection and factory service
ANC PAD
schedule. Do not use if inspection
reveals an unsafe condition.
K
DEPRESS BUTTON
TO BYPASS ALARM
A CAPITAL SAFETY BRAND
www.capitalsafety.com
(800)328-6146
80-150 PSI
M
OBI OK
SPECIFICATIONS
This apparatus is intrinsically
safe and is suitable for use in
Self Contained Vacuum Anchor
Class I, Division 1, Group D,
T4 @ Ta = 115°F (46°C) max
hazardous locations
Materials of construction:
Natural Rubber/Polybutadiene
Aluminum
Capacity:
One user, 310 lbs. (141 Kg)
Anchor strength:
3,375 lbs. minumum (15 kN)
Maximum Surface Temperature:
140°F (60°C)
Patent No:
US 6,547,033
GB 2,313,396
AU 712,249
OTHER PATENTS PENDING
WARNING
This device is not user repairable. To
reduce the risk of ignition of a ammable
or explosive atmosphere, batteries must be
changed only in a location known to be non-
hazardous. For replacement batteries, use
only Capital Safety part number 9501987. To
reduce the risk of explosion, do not mix old
batteries with used batteries. See
manufacturer's instructions (5902400) for
more information.
H
3
B
C
2
B
A
WARNING
M
Manufacturer's instructions must be read and
Structure to which the vacuum anchor is
understood prior to use. Instructions supplied
attached must be capable of supporting the
with this product at time of shipment must be
loads imposed by the vacuum anchor due to
followed. This anchorage device must only be
fall arrest, see user manual. Locate vacuum
installed and used under the super- vision
anchor and rig fall arrest system to minimize
of a quali ed person as part of a complete
free fall and swing fall hazards. Ensure
personal fall arrest system, which maintains
su cient clearance exists in the work area
a safety factor of at least two. Do not use
to avoid striking an object or lower level
vacuum anchor where pad will not seal properly
should a fall occur. Clean area where pad is
or leakage is apparent. Do not attach vacuum
to be attached of loose debris and excess
anchor to structurally inappropriate materials
moisture before applying vacuum. A full body
or surfaces. Refer to user manual for temperature
harness is recommended for use with this
operation limits. Alteration or misuse of this
device. Avoid lanyard contact with sharp
product, or failure to follow instructions may
edges. If alarm sounds, move to a safe area
result in serious injury or death.
and disconnect from vacuum anchor until
normal operation resumes. For use by trained
persons only. See user manual for more
details. Do not remove this label.
R
X
L -
3,000 psi
(20 MPa)
ement and other safety information.
LOG
DATE
G
3
C
WARNING
D
E
ATTACH
F
RELEASE
TM
ct is i-Safe enabled and contains an
c tag that can be read by compatible
- providing inspection logs, inventory
INITIAL
4
Publicidad
Tabla de contenido
