Roubleshooting Uide - GE 26925 Guia Del Usuario

T
ROUBLESHOOTING
In case of difficulty, please check the following Troubleshooting Guide
before seeking service.
Problem
No dial tone
Dial tone is OK, but
can't dial out
Handset does not ring
Cannot hear phone
conversation
You experience static,
noise, or fading in
and out
G
UIDE
Solution
• Check installation:
— Is the base power cord connected to a working outlet?
— Is LINE 1/LINE 2 indicator on?
— Is the telephone line cord connected to the base unit and
the wall jack?
— Is a headset connected to the handset? The handset
receiver and microphone are temporarily disabled when
you connect the headset
• Disconnect the base from the wall jack and connect another
phone to the same jack. If there is no dial tone in the second
phone, the problem might be your wiring or local service.
• Is the handset out of the base unit's range? Move closer to
the base unit.
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly?
• If the phone still does not work, disconnect the power cord
and remove the battery pack. Then reconnect the power cord
and reinstall the battery pack. Place handset in the base for 20
seconds to allow it to reinitialize.
• Make sure the T/P switch on the base is set
correctly.
• Make sure the RING switch on the handset is turned to ON.
• You may have too many extension phones on your line. Try
unplugging some phones.
• See solutions for "No dial tone. "
• Set the volume control on side of handset to HI.
• Change channels.
• Is handset out of range? Move closer to the base.
• Does the base need to be relocated?
• Charge handset battery.
• Make sure base is not plugged into an outlet with another
household appliance.
25