NO DATA
PAGING FROM BASE
PRESS TALK KEY
REPEAT
UNKNOWN NAME/
CALLER/NUMBER
T
ROUBLESHOOTING
C
P
ORDLESS
HONE
No dial tone
•
Check installation:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base unit and the wall phone jack.
•
Connect another phone to the same modular jack; if the second phone doesn't work, the
problem might be with your wiring or local service.
•
The handset may be out of range of the base. Move closer to the base.
•
Make sure the battery is properly charged (for 16 hours).
•
Ensure the battery pack is installed correctly.
•
Did the handset beep when you pressed theTALK/call back button? Did the charge/in use
indicator come on?The battery may need to be charged.
•
Place the handset in the base for at least 20 seconds.
Handset does not ring
•
Make sure the RINGER switch on the handset is turned ON.
•
Move closer to the base.The handset may be out of range.
•
You may have too many extension phones on your line.Try unplugging some phones.
•
Check for a dial tone.
You experience static, noise, or fading in and out
•
Change channels.
•
Move closer to base.The handset might be out of range.
•
Relocate the base. Make sure base is not plugged into an electrical outlet with another
household appliance.
•
Charge the battery.
No Caller ID information was received.
The PAGE button has been pressed on the base.
Indicates the CID number is a Direct Dial Number (DDN) and cannot
be formatted.
Repeat call message. Indicates that a new call from the same
number was received more than once.
The incoming call is from an area not serviced by
Caller ID or the information was not sent.
G
UIDE
S
OLUTIONS
29