Sauder Cornerstone Serie Manual Del Usuario página 9

Step 5
Remove the Molding and two Metal Brackets from the
å
Top. Fasten the Return Molding (from the Desk) to the
remaining Metal Brackets on the Top.
Fasten the Turnbuckle and the shorter Support Rod to
å
the Top again using the Screws you removed from the
Support Rod earlier.
Slide the SPACER (O) under the short Support Rod as
å
close to the fastened end of the Support Rod as possible.
Now, tighten the Turnbuckle.
Molding
www.sauder.com/services
Remove these
Metal Brackets
404972 Executive Desk
O
Return Molding
404380
Return on the RIGHT
404972 Executive Desk
Support Rod
Turnbuckle
Flat edge
Page 9