Maxon GPT Serie Instrucciones Instalación página 2

LIFT CORPORATION Sht. 2 of 10 DSG#
MOUNTING GPT WITH INTEGRATED EXTENSION PLATE
Liftgate installation is not complete until these kit instructions are completed
along with the instructions in the GPT Installation Manual.
Prevent damage to hydraulic hoses. If welding next to hydraulic hoses, use a
protective cover such as a welding blanket to cover the hoses.
To protect the original paint system if equipped, a 3" wide area of paint must
be removed from all sides of the weld area before welding.
When using an electric welder, connect the welder ground to one of the parts
being welded, as close to the weld as possible. Failure to comply could result
in damage to cylinders and electrical parts.
1. Weld Liftgate to vehicle chassis as shown in FIG. 2-1.
Repeat for LH side.
KEEP FLUSH
WITH TRUCK
BODY
© MAXON Lift Corp. 2021
CAUTION
CAUTION
CAUTION
CAUTION
25-1/2"
23-7/8"
WELDING LIFTGATE TO VEHICLE CHASSIS
(RH SIDE SHOWN)
FIG. 2-1
M-20-07
Rev. A - Date: 01/16/21
ALL TOUCHING
SURFACES
1/4"
(5 PLACES)
22-1/2"