Installation of Top Case Carrier
Plate
1. Insert the spacer (long) and
spacers (short) into the pillion
rider handle cover hole.
2. Install the top case carrier plate.
Tighten the screw (long) and
screws (short) to the specified
torque.
Tightening torque: 13 N·m
(1.3 kgf-m, 9.5 lbf-ft)
3. Stick a label to the top case car-
rier plate, if necessary.
4. Close the seat.
Caution for Handling
This top case carrier plate has been designed so that the SUZUKI genu-
ine top case designated specially for this model can be installed.
When baggage is to be loaded, attach the SUZUKI genuine top case
specially designed for this model, and put baggage in it. Do not put bag-
gage directly on this top case carrier plate. Read carefully the instruction
manual for the top case for handling.
Spacer (short)
Spacer (short)
Spacer (short)
Screw (short)
Screw (short)
Top case carrier plate
Top case carrier plate
Label
20 mm
GENUINE SUZUKI ACCESSORIES
5/5
Spacer (long)
Spacer (long)
Spacer (long)
Screw (long)
Screw (long)