SMA NR-STP150H-ACCON Manual De Instrucciones página 25

SMA Solar Technology AG
3. Check whether spacers are in place at the
appropriate positions on the rear side of the H-AC-
CON. If any spacers are missing, insert the supplied
spacers in these positions on the H-AC-CON.
4. Check whether the plug-in jumper is plugged into
the terminal on the H-AC-CON. If the plug-in jumper
is missing, plug the supplied plug-in jumper into the
terminal on the H-AC-CON.
5. Lead the cable harness through the drill hole in the
H-AC-CON.
6. Align the H-AC-CON and insert in the inverter. Ensure that the printed circuit board retaining
clips snap into place correctly.
7. Tighten all connecting screws (3.5 Nm). Use the screws supplied and follow the sequence
shown.
Replacement Manual
7 Installing the H-AC-CON
STPTL-30-H-AC-CON-RM-xx-10 25