MSA Gallet F2XR Manual De Instrucciones página 9

GB
Removal
Use
NOTE: It is preferable to store the goggles inside the helmet when not used to avoid premature wearing of the
straps (loss of elastic tension).
5.2 Eye and Face Protection Visors
Face shields will provide protection to the eyes and substantial areas of the face.
WARNING!
• Important Information on Visors (Ocular Visor and Face Shields):
• Users should ensure the correct type of visor is fitted to their helmet for their intended activity.
• The stated levels of protection are only provided when the visor is fully in the in-use protective position.
• Ocular visors will offer little or no protection to substantial areas of the face. They must only be used
where an adequate risk assessment indicates that facial protection is not required.
• Mesh face shields are not suitable for wildland firefighting and only suitable for non-firefighting
associated activities such as wood cutting, road clearance, etc. Additionally, they should not be used
where there is a risk of exposure to heat, flame, sparks, splashes of harmful or molten liquids, or
electricity.
• Visors meeting the requirements for electrical properties according to EN 14458 provide limited
protection (brief accidental unintended contact with live low voltage conductors), and all component
parts of a visor/helmet assembly shall have the same marking to achieve this.
• Visors worn over non-designated corrective frames may transmit impacts which may damage the
corrective eyewear thus creating a hazard to the user.
• Keep the visor in standby position (stowed under the helmet shell) during the use of a breathing
apparatus (SCBA).
• Do not wear a face shield over an SCBA face piece.
• Service life of visors depends on the conditions of use.
• Any visor or face shield that has been dropped or damaged must be replaced.
• Visors shall be regularly inspected. Any visor with a scratched or damaged lens must be replaced.
(1) Push the plastic clip and slide it out of the
attachment slot.
(1) Grab the goggle frame with both hands and bring
it down under the helmet brim.
(2) Adjust elastic band on the face by pulling the
straps to the rare, to optimize comfort and
protection.
(3) To put the helmet back in standby position, pull
the elastic band clips forward and bring the frame
on the helmet shell
5 Gallet F2XR Accessories
9