Important; Downrod-Style Fan Mounting - Harbor Breeze TG44LW3D1RS Manual De Instrucciones

INITIAL INSTALLATION
Secure mounting bracket (C) to outlet box (not
8.
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket
(C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling, and
ensure the ceiling angle is not steeper than 19°.
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 11.

DOWNROD-STYLE FAN MOUNTING

1a.
Remove pin (L) and clip (M) from downrod (A).
1b.
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (D).
8
STANDARD
MOUNT
C
1a
M
Yoke
D
9
ANGLE
MOUNT
C
Open End
1b
A
L
Set Screw
& Nut