Normal Or Angle Style Fan Mounting - Harbor Breeze PLM52CB5D Manual De Instrucciones

INITIAL INSTALLATION
5. Remove motor screws (J) and lock washers (K)
from underside of motor and save for bade arm
(P) attachment later on. [If there are plastic motor
blocks installed with the motor screws (J) and
lock washers (K), discard the plastic motor
blocks.] (Fig. 5)
FAN MOUNTING
1.
Remove pin (M) and clip (N) from downrod (A). (Fig. 1A)
Partially loosen set screws in motor housing yoke at top
of motor housing (D). (Fig. 1B)
*Helpful Hint: Downrod style mounting is best suited for
ceilings 8 ft. (2.44 m) high or higher. For taller ceilings
you may want to use a longer downrod (sold separately)
than the ones provided. Angle style mounting is best
suited for angled or vaulted ceilings. A longer downrod
is sometimes necessary to ensure proper blade
clearance.
2. Choose downrod (A) length you wish to use.* If you
choose to use the 12 in. downrod (A), remove
hanging ball from the 6 in. downrod (A) and attach to
the 12 in. downrod (A). Insert downrod (A) through
canopy (B), canopy cover (I), and yoke cover (F).
(Fig. 2). [Note: Canopy cover (I) must be turned with
the shiny side toward the motor housing (D).] Thread
wires from motor housing (D) through downrod (A).
3.
Slip downrod (A) into housing yoke, align holes and
re-install pin (M) and clip (N). Tighten downrod set
screws and then tighten nuts. Slide yoke cover (F)
down until it rests on top of motor housing (D). (Fig. 3)
5
1A
A
N
2
Hanging
B
3
A
D
7
K
D
1B
M
Ball
F
F
Set
Screw
N
M
J
Set
Screw
D
I