Use And Operation - Klarstein AIRFLEX 360 Manual Del Usuario

USE AND OPERATION

Installation
1. Take out parts for assembling.
2. Put the power cord through the hole of base, stand the support on the base
and fix them tightly by screw (Picture 1).
3. Place the machine body into the tube-shape pillar (Picture 2).
4. Then, take out the grub screw and cross screwdriver to fix the body on the
tube-shape pillar (Picture 3).
5. After the below installation, plug in and operate according to the following
instructions when placing on the flat ground (Picture 4).
Operation
Touch screen control technic has been used in this unit, all of unit's function can
be operated by touch the display window signs slightly. NOTE: When plug in, the
machine shows proper insert on the condition that all LED lights turn on for 2
seconds and BIBI sounds; then, all LED lights turn off and leave it on Standby;
besides the STAND-BY, no button is workable.
Standby Mode
Under standby state, no button is workable but STAND-BY; The machine starts to
work by press STAND-BY, which shows the the initial wind mode as "Normal" and
wind speed stays on "Low", having accordingly LED light show; without timer and
swing function.
On the other hand, under standby state, when plug in for the first time, the body
sensor function is available; the working instructions like wind speed mode and
oscillation for the last time will all be conserved on the condition that the power is
on and the machine starts for at least for the second time (Timing hours will not
be conserved under sleeping mode).
EN
19