Use And Operation - Klarstein Bolero Manual Del Usuario

EN
12
10
Install the light bulb
(max 60 W E14
not supplied) to the
lampholder.

USE AND OPERATION

• Select the fan speed by pressing the speed control button on the remote control
transmitter: HI: High Speed - MED: Medium Speed - LOW: Low Speed - OFF: Off.
• The switch on the motor housing for controlling the fan blades rotating direction
controls the direction of the air movement. Caution: Before using this rotating
direction switch, turn OFF the fan and ensure the fan stops rotating to prevent injury
to yourself and damage to the motor.
• Cold weather: Push the switch "UP" so that the rotor blades will bring the warm air
trapped near the ceiling fan to move downwards throughout the room.
• Hot weather: Push switch "DOWN"so that the rotor blades will create a breeze and
circulate the air to the room.
• Pressing the "ON/OFF" light button on the remote control transmitter can control
the turning on or off of the light.
Remote Control
• Use the remote control transmitter to change the speed of the fan and to switch the
light and fan on or off.
• Replace the batteries by sliding the battery compartment cover on the remote
control transmitter in the direction of the arrow, fit 2 x "AAA" batteries, ensure the
polarity of the batteries match with the figures shown in the battery compartment.
(Note: Batteries NOT included). Re-assemble the battery compartment cover.
• ALWAYS ensure the battery compartment cover is closed properly. DO NOT
expose the remote control to direct sunlight.
• DO NOT attempt to recharge expired batteries. There are special rechargeable
batteries, which are clearly marked with. DO NOT dispose of batteries in fire to
avoid explosion.
11
Install the lampshade
onto the shade
gallery by rotating the
lampshade clockwise.