ELICA EN ISLA Montaje Y Modo De Empleo página 31

Operation
T1. Button ON/OFF lights
T2. Button to decrease suction speed (power)
OFF 1: press repeatedly to decrease the speed until you
turn off the hood
OFF 2: at any speed press and hold for a longer time
T3. Button ON/to increasesuction speed (power) (1-2-3-
Intensive) / Timer
Intensive speed has a duration of approx. 5 minutes,
then speed 3 is automatically set.
To program the automatic switch-off (Timer) press and
hold for a longer time; the shutoff time changes according
to the set speed:
Speed 1: 20 minutes
Speed 2: 15 minutes
Speed 3: 10 minutes
Intensive speed: 5 minutes
Filter Saturation Indicator
The hood signals when necessary to perform filter
maintenance:
Grease filter (every 40 hours of use): all Leds with red light
Activated charcoal odour filter (every 160 hours of
operation): all LEDs with red light, LEDs L2 and L3 blink
Reset Filter Saturation
After performing filter maintenance, press and hold buttons T1
and T3, Leds L1, L2 and L3 blink briefly in red and then turn
off for good.
Activation indicator for odour filter saturation with
activated charcoal
This indicator is normally disabled. To enable it, proceed
as follows:
With the hood off, press and hold simultaneously T1
and T2: L1 turns on first, then L2 and L3 and after that,
when the buttons are released, the Leds L2 and L3 flash
briefly to indicate successful activation.
Disabling the LED for charcoal filter saturation:
repeat the operation above; first the LEDs L1, L2 and L3
turn on simultaneously, then only L1, and after that, when
the buttons are released, the leds L1, L2 and L3 turn on
again to indicate successful disabling.
Maintenance
Cleaning
Clean using ONLY the cloth dampened with neutral liquid
detergent. DO
INSTRUMENTS. Do not use abrasive products. DO NOT USE
ALCOHOL!
Grease filter
Fig. 28-30
Traps cooking grease particles.
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity) using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may discolour
slightly, but this does not affect its filtering capacity.
External grid cleaning:
It should be cleaned with the same frequency as the
grease filter.
Use a cloth moistened with neutral liquid detergent..
Avoid the use of abrasive products.
DO NOT USE ALCOHOL!
Charcoal filter (filter version only)
Fig. 29
It absorbs unpleasant odours caused by cooking.
The saturation of the charcoal filter occurs after more or less
prolonged use, depending on the type of cooking and the
regularity of cleaning of the grease filter.
In any case it is necessary to replace the cartridge at least
every four months.
The charcoal filter may NOT be washed or regenerated.
Replacing lamps
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10
times as long as the traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the technical service.
32
NOT CLEAN WITH TOOLS OR